Replacing servomotor
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... RAISING THE VEHICLE WITH A VEHICLE LIFT .
WARNING:
Hot exhaust system
.
Risk of burning!
Risk of burning!
- Any work must exclusively be carried out with an exhaust system that has cooled down.
Preliminary work
- Refer to REMOVING THE COVER OF THE RIGHT CAMBER CONTROL ARM .
- Refer to RELEASING THE WIRING HARNESS FROM THE M SPORT DIFFERENTIAL .
- Loosen screws (2).
- Feed out the servomotor (1) with the holder and remove it.
- Replace the servomotor (1).
Parts: Servomotor
- Mount the O-ring (2) on the servomotor (1).
NOTE:
TECHNICAL INFORMATION
The gearing of servomotor and idler gear must be checked and the positive locking ensured.
The gearing of servomotor and idler gear must be checked and the positive locking ensured.
- Guide in servomotor (1) with the holder and position.
The servomotor (1) must be flush against the cover of the rear differential.
- Replace screws (2).
Parts: Screws
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATION
| Servomotor on rear axle differential | ||
| M6 Replace screws. |
tightening torque | 9 Nm |
Follow-up work