Install charge air line

• Check sealing ring (1) on the charge air line (3) for damage, if necessary replace with the special tool 0 496 714 (00 9030)  .
• Check sealing ring (2) on the charge air line (3) for damage, if necessary replace with the special tool 0 496 714 (00 9030)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install charge air line (4).
• Lock clamp (3).

  The clamp (3) must engage audibly.

• Insert and install the coolant hose (2).
• Lock clamp (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (3).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Charge air line to throttle valve
  M6x30	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (2) and lock.

  The connector (2) must engage audibly,

• Connect connectors (1)  and lock.

  The connector (1)  must engage audibly,

• Feed in and position auxiliary coolant pump (4).
• Feed in and position retaining bracket (3). 
• Tighten nut (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Electric coolant pump to holder
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.

  The connector (1) must engage audibly,

Follow-up work 

• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to IF INSTALLED: INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT (PARTIALLY REMOVED) .
• Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING ACOUSTIC COVER .