Install catalytic converter
- Replace the V-clip (1).
Parts: V-band clamp
- Replace the seal (1).
Parts: Seal
- Feed in and install catalytic converter.
- Lock clamp (1).
Clamp (1) must engage audibly.
- Tighten V-clip (1).
TIGHTENING TORQUE SPECIFICATION
| Catalytic converter to exhaust turbocharger | ||
| V-band clamp Replace V-band clamp. |
Tightening torque | 19 Nm |
- Replace nuts (1).
Parts: Nuts
- Tighten nuts (1).
TIGHTENING TORQUE SPECIFICATION
| Catalytic converter to holder | ||
| M8 Nut Replace nut. |
Tightening torque | 19 Nm |
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Replace pressure hose (1)
Parts: Pressure hose
- Insert the pressure hose (1) in the arrow direction all the way to the stop.
Follow-up work
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE RIGHT FRONT-END STRUT .
- Refer to INSTALLING ACOUSTIC COVER .