Installing the rollover protection
- With the aid of a support person, feed in the rollover protection (2) from above.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Roll-over protection to body | ||
| Screw Replace screw. |
tightening torque | 50 Nm |
NOTE:
Perform the steps on the left and right side.
- Position seat belt guide bracket (2).
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
- Position the holder (3) and tighten the nuts (2).
- Position the wiring harness (1) and clip it to the brackets.
- Connect all the available plug connections and lock them.
- Position the LTE antenna (3).
- Tighten down screw (2).
- Connect plug connection (1) and lock.
Follow-up work
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING THE TELEMATICS CONTROL MODULE .
- Refer to INSTALLING THE RADIO REMOTE CONTROL RECEIVER .
- Refer to INSTALLING THE LOWER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
- Refer to INSTALLING THE TRIM PANEL ON THE THROUGH-LOADING SYSTEM .
- Refer to INSTALLING THE COVER FOR CROSS MEMBER AT THE TOP .
- Refer to INSTALLING THE UPPER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
- Refer to INSTALLING THE REAR LEFT AND RIGHT HEAD RESTRAINT GUIDES .
- Refer to INSTALLING REAR LEFT AND RIGHT HEAD RESTRAINTS .
- Refer to INSTALLING THE REAR SEAT .
- Refer to CHECKING THE ROLL BAR .