Install the telematics control module
- Correctly position the telematics control module (3).
- Tighten nuts (2).
TIGHTENING TORQUE SPECIFICATION
| Telematics control module on holder | ||
| Nut | tightening torque | 3.3 Nm |
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING THE LOWER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
- Refer to INSTALLING THE TRIM PANEL ON THE THROUGH-LOADING SYSTEM .
- Refer to INSTALLING THE UPPER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
- Refer to INSTALLING THE REAR LEFT AND RIGHT HEAD RESTRAINT GUIDES .
- Refer to INSTALLING REAR LEFT AND RIGHT HEAD RESTRAINTS .
- Refer to INSTALLING THE REAR SEAT .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .