Installing starter motor

• Make sure that the acoustic cover (1) is not damaged.
• Carefully push the acoustic cover (1) aside.
• Insert and install the starter (3) in the direction of the arrow.
• Tighten down screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the acoustic cover (2).
• Fasten expanding rivet (1).
• Secure clamps (arrow).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the christmas tree clip (2).
• Secure expanding rivet (1).
• Secure the clamps (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten positive battery cable (3) in holder (4) and position it on the starter motor.
• Tighten the nut (2) hand-tight.
• Connect connectors (1) and lock audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly  attach the positive battery cable (1) to the anti-twist lock (2).
• Tighten the nut (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .