Install front ornamental grille
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
Check
- Check detents (arrows) for damage.
Result
» The detents (arrows) are damaged.
Measure
- Replace center front radiator grill.
- Clip in the front radiator grille with the detents (arrows) into the bumper cover.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Hook the wiring harness (3) into all the holders on the front radiator grille.
- Clip in the wiring harness (3) with the holder (4) .
- Feed in the ultrasonic sensors (2) into the front radiator grille and clip it into the detents (1) .
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Feed in the front camera (1) into the front radiator grille and clip it into the detents (2) .
Follow-up work
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING THE FRONT EMBLEM .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .