Installing crash lever
NOTE:
Perform the steps on the right and left side.
NOTE:
The following step (s) must be performed if the listed component (s) is/are installed.
- Position the crash lever (3) on the front subframe.
- Tighten screws (1) and (2) .
TIGHTENING TORQUE SPECIFICATION
| Crash lever on frame/adapter of front subframe | ||
| M14 | tightening torque | 100 Nm |
Follow-up work
- Refer to INSTALLING BOTTOM FRONT COVER FROM THE SIDE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .