Installing both actuators

• Check the seal (1)  for damage; if necessary, replace the actuator (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The figure shows the rear of the engine.
• Position both actuators.
• Connect and lock both connectors (1)  .

  The connectors (1)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The figure shows the rear of the engine.
• Position special tool 2 360 895  correctly on the actuator (1)  of the exhaust side.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1)  of the exhaust side and turn in the arrow direction with the special tool 2 360 895  until the limit stops tap the clamps.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The figure shows the rear of the engine.
• Position special tool 2 360 895  correctly on the actuator (1)  of the intake side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1)  of the intake side and turn in the arrow direction with the special tool 2 360 895  until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING CENTER BULKHEAD LOWER PART .
• Refer to SECURING THE HIGH-VOLTAGE CABLES ON THE EME .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING THE CENTER COWL UPPER PART .
• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .