Installing the flange supports on the component carrier
- Check the sealing ring (1)
on the flange supports (2)
for damage and replace the sealing ring (1)
as needed.
Parts: Sealing ring
- Coat the sealing ring (1)
with coolant.
- Insert and install the flange supports (3) .
- Tighten the screws (2)
.TIGHTENING TORQUE SPECIFICATION
Flange connector on component carrier M6x20 tightening torque 8 Nm - Connect and lock coolant line (1) .
The coolant line (1) must audibly lock.
Follow-up work
- Refer to INSTALLING COOLANT LINE BETWEEN THE COOLANT PUMP AND CYLINDER HEAD .
- Refer to INSTALLING THE DRIVE BELT FOR THE COOLANT PUMP .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING THE CLEAN AIR PIPE WITH THE RESONATOR .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .