Installing the left and right headlight

Checking blocking of the horizontal setting 

• Feed in and correctly position the headlight (1).

  The detent (2) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• (2) Connect and lock the connector plug with the headlamps (3).
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front light combination, top
  Screw	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front light combination, bottom
  Screw	5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the adhesive tape in area (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
• Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH TRIMS .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING THE COVER PANEL IN THE ENGINE COMPARTMENT AT THE TOP LEFT .
• Refer to WHEN REPLACING LASER HEADLIGHTS: PROGRAM/ENCODE THE INTEGRATED LASER CONTROL UNIT .
• Refer to ADJUSTING HEADLIGHTS .