Remount the LED module for the right turn signal lamp

Removing the LED module for the turn signal bulb 

• Loosen screws (1).
• Pull LED module (2) out of headlight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect the plug connection (1) on the LED module (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the LED module for the turn indicator bulb 

• Check the seal (1) on the LED module (2) for damage and replace as needed.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (1) with the LED module (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the LED module (2) on the headlamp.
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING RIGHT HEADLIGHT .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
• Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH TRIMS .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE UPPER RIGHT .
• Refer to PROCESSING THE LED HEADLIGHT SERVICE TEST MODULE .
• Refer to ADJUSTING HEADLIGHTS .