Installing all ignition coils
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
Install ignition coil
- Feed in and install the ignition coil (3).
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Ignition coil screw tightening torque 8 Nm - Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Guide in and position the cable holder (2).
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Oxygen sensor bracket to cylinder head cover Self-tapping screw M6 tightening torque 5.5 Nm - Connect connectors (1) and lock.
The connectors (1) must engage audibly.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .