Installing the steering column switch cluster (SZL)
- For replacement:
Break off the transportation retainer (1) on the steering column switch cluster (SZL) (2) in arrow direction.
The fragment (3) of the transportation retainer (1) remains in the steering column switch cluster (SZL) (2).
- Connect the connector (1) with the steering column switch cluster (SZL) (2).
- Position the steering column switch cluster (SZL) (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Steering column switch cluster (SZL) to steering column | ||
|---|---|---|
| Screw TS5x20 | Tightening torque | 3 Nm |
Follow-up work
- Refer to FITTING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to INSTALLING STEERING COLUMN SHROUD LOWER SECTION .
- Refer to INSTALLING STEERING WHEEL .
- Refer to INSTALLING AIRBAG UNIT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .