Installing starter motor
- Insert and install the starter motor (2).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Starter motor to crankcase M8x60 tightening torque 19 Nm - Insert the positive battery cable (3) and install it.
- Tighten the nut (2) hand-tight.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
CAUTION: Improper routing of the positive battery cable .
Risk of short circuits!- Route the positive battery cable without abrasions and do not trap.
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Attach the positive battery cable (1) correctly to anti-twist lock (2).
- Tighten nut (3).TIGHTENING TORQUES SPECIFICATION
Battery positive lead to starter M8 tightening torque 15 Nm
Follow-up work
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .