Installing the crankshaft sensor

• Feed in and install the crankshaft sensor (3).
• Tighten down screw (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Crankshaft sensor to crankcase
  TS5x20	tightening torque	4.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

Follow-up work 

• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .