Remount ultrasonic sensors

• Unlock the detents (1).
• Remove the ultrasonic sensor (2) towards the top.
• Remove all other ultrasonic sensors together with the wiring harness.
• Replace the ultrasonic sensors.

  Parts:  Ultrasonic sensors

• Snap all ultrasonic sensors into the bumper.
• Secure wiring harness.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL AT LEFT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .