Installing the rear bumper cover

• Connect the plug connections and install bumper cover (2).
• Snap the bumper cover (2) into the locks (3) at the top.
• Snap the bumper cover (2) into the remaining locks on the side and at the bottom.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper cover to guide, middle

  2.7 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper cover to side guide
  Screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL AT LEFT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .