Installing the output shaft
NOTE:
The figure shows the procedure for the front axle differential. The procedure for the bearing bracket is identical.
- Fold open the assembly protection ring (1)
.
- Insert the output shaft into the front axle transmission and/or the bearing bracket.
- Pull on the lug (1) of the assembly protection ring until one of the two predetermined breaking points breaks.
- Pull out and dispose of the installation protection ring.
- Slide the output shaft (1)
into front axle transmission or bearing bracket up to the stop.
Output shaft coupling must snap audibly into place.
Follow-up work
- Refer to CHECK/ADD FRONT AXLE TRANSMISSION OIL .
- Refer to INSTALLING THE REAR THRUST FIELD .
- Refer to INSTALLING FRONT STIFFENING PLATE .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING SPRING SUSPENSION STRUT .
- Refer to SECURING THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT .
- Refer to SECURING THE FRONT AIR SUSPENSION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to GREASE THE WHEEL HUB .
- Refer to ATTACHING THE FRONT LEFT WHEEL .