Installing the holder for the DME control unit on the left
- Insert and install the holder (4) for the DME control unit on the left.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder for Digital Motor Electronics control unit to body | ||
| M6x13 | Tightening torque | 8 Nm |
- Attach the refrigerant line to the clip (2).
- Lock the lock (3).
Follow-up work
- Refer to INSTALLING THE DME CONTROL UNIT FOR CYLINDERS 7 TO 12 .
- Refer to CHECKING THE COOLANT LEVEL IN THE LOW-TEMPERATURE COOLANT CIRCUIT AND TOPPING UP, IF NEEDED .
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .