Remove complete exhaust system
NOTE:
TECHNICAL INFORMATION
Mount the exhaust system in a de-energized state, following the tightening sequence from the rear silencer towards the exhaust manifold.
Mount the exhaust system in a de-energized state, following the tightening sequence from the rear silencer towards the exhaust manifold.
Preliminary work
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING THE RIGHT REAR TORSION STRUT .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Component with heavy weight
.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
- Version 1 (Ribbon clamp)
Detach the ribbon clamp (1) .
- Version 2 (V-band clamp)
Unfasten circlip (1) .
- Loosen nut (1)
.
- Release the nut (1)
on the rear axle support.
- Unlock plug connection (1) and disconnect.
- Loosen nuts (2) .
- Lower and remove the exhaust system (3)
with the assistance of a second person.