Install the Head unit High (HU-H)
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
NOTE:
RISK OF DAMAGE
Damage to the head unit.
The hard disk of the head unit can be damaged by vibrations.
Damage to the head unit.
The hard disk of the head unit can be damaged by vibrations.
- Carry out mechanical work on the head unit and adjacent components with care.
- Position the head unit (1) .
- Connect and lock all connectors in marked area.
- Feed in the head unit (2) from above and move it into position.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Head unit on holder/holder on support Screw tightening torque 1.8 Nm Installing the air duct in the center dashboard
- Insert and install the air duct (2) .
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Air duct to dashboard support Screw
Replace screws.tightening torque 1.8 Nm
Follow-up work
- Refer to INSTALLING AUDIO CONTROL UNIT .
- Refer to INSTALLING DECORATIVE STRIP ON CENTER OF DASHBOARD .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .
- Refer to INSTALLING THE CORRECT NAVIGATION MAP .
- Refer to IMPORTING THE SERVICE HISTORY .
- Refer to INITIALIZING COMPONENT PROTECTION .