27 10 730 Replacing transfer box control unit (longitudinal torque module) (ATC 45L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 1 200
11 1 380
23 0 490

IMPORTANT: Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.
READ AND COMPLY WITH NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD .
Remove transmission cross member . See 22 32 050 REPLACING CROSS MEMBER FOR TRANSMISSION MOUNTING .

Disconnect connector (1).

Release screws (2) and remove transfer box from control unit (longitudinal torque module) (3).

Tightening torque 27 10 3AZ .

NOTE: Radial shaft seal of actuator shaft must be replaced as well.

Fig 1: Identifying VTG Control Unit, Connector And Screws

G09921697

Courtesy of BMW OF NORTH AMERICA, INC.

Thread special tool 23 0 490 into radial shaft seal (1).

Drive out radial shaft seal (1) with impact weight (2).

Fig 2: Removing Radial Shaft Seal

G08504531

Courtesy of BMW OF NORTH AMERICA, INC.

Push the assembly sleeve 11 1 380 over the actuator shaft.

IMPORTANT: Nonobservance involves a risk of damage to the radial shaft seal.

Fig 3: Identifying Special Tool (11 1 380)

G08504532

Courtesy of BMW OF NORTH AMERICA, INC.

Slide the new radial shaft seal (1) over the assembly sleeve (2) onto the actuator shaft.

Fig 4: Sliding Radial Shaft Seal Over Assembly Sleeve Onto Actuator Shaft

G08504533

Courtesy of BMW OF NORTH AMERICA, INC.

Drive radial shaft seal fully home using special tool 11 1 200 and plastic hammer.

Remove the assembly sleeve.

Fig 5: Installing Radial Shaft Seal

G08504534

Courtesy of BMW OF NORTH AMERICA, INC.

After replacement:

CARRY out programming/encoding.