Installing the door weather strip on the rear door
NOTE:
TECHNICAL INFORMATION
The repair notes of bonded seals form the basis for these repair notes and must be observed without fail.
For ADDITIONAL INFORMATION see: 54 10... Repair notes for bonded seals
The repair notes of bonded seals form the basis for these repair notes and must be observed without fail.
For ADDITIONAL INFORMATION see: 54 10... Repair notes for bonded seals
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Hang the door weather strip (1) over rear the door with the open lip facing inwards.
- Sealing joint in area (A) position.
- Bond the door weather strip (1) as follows:
- Gradually detach protective film
- Align the door weather strip (1) corresponding to the specified dimensions (X) or the templates and press on lightly
- Check the position of the door weather strip (1) and correct if necessary
- Do not overstretch or compress the door weather strip (1) when positioning it
- Maximum permissible sag of the door weather strip (1) during the positioning process is 30 mm
- Always apply pressure perpendicular to the bonding surface to affix the door weather strip (1)
- Affix the door weather strip (1) with firm thumb pressure
| Area | Dimension x |
|---|---|
| A | 8 mm |
| B | 10 mm |
| C | 5.5 mm |
| D | 4 mm |
- Create a sealing joint in area (A), and shorten the door weather strip (1) accordingly as needed.
- Position the door weather strip (1) along the template (3):
The edge of the door weather strip (1) is flush with the mark (4) of the template (3).
- Door weather strip
- Adhesive strip of door weather strip
- Template
- Mark for the door weather strip
Follow-up work