Installing The Engine Compartment Lid Hinge, Right

• Position the hood hinge (3).
• Tighten down screws (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Hood hinge
  M8 screw
  	Tightening torque
  	28 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the cable clip (1).
• Clip jet chain (1) with holder (2) onto hood hinge.
• Clip in the holder (3) on the hood hinge.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Place gas spring (1) onto the ball head and engage the lock (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE ACTUATOR ON THE RIGHT HOOD HINGE .
• Refer to INSTALL HOOD .
• Refer to INSTALLING JET CHAIN PARTIALLY .
• Refer to CHECK THE GAP DIMENSION OF THE HOOD .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .