13 71 000 Removing and installing/replacing intake silencer housing (I01)

WARNING: High-voltage system - danger to life

Compliance with the following points is mandatory before beginning work:

Necessary preliminary tasks:

Unclip control unit (1) from intake silencer housing and set aside.

Release clamp (2) and pull clean air pipe off of intake silencer housing.

Tightening torque 13 71 4AZ .

Pull raw air pipe (3) off of intake silencer housing.

Release screws (4).

Tightening torque 13 71 1AZ .

Remove intake silencer housing.

Fig 1: Identifying Intake Silencer Housing Control Unit, Clamp, Raw Air Pipe And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.