51 16 040 Removing and installing/replacing housing on left or right exterior mirror

Necessary preliminary tasks:

Release screws (1).

Tightening torque 51 16 5AZ .

Fig 1: Identifying Exterior Mirror Housing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Remove housing (2) carefully and disconnect plug connection at side repeater (3).

Fig 2: Identifying Housing, Side Repeater And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure retaining ring (1) is correctly mounted on side repeater (2) and housing (3).

Fig 3: Identifying Turn Indicator, Housing And Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Screw holes (1) must not be damaged.

Replacement:

Feed side repeater (2) out of housing (3) in direction of arrow.

Fig 4: Removing Side Repeater Out Of Housing

Courtesy of BMW OF NORTH AMERICA, INC.