51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT DOOR SILL COVER STRIP (INSIDE)
- Remove trim panel for pedal mechanism . See 51 45 184 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR PEDAL ASSEMBLY (ECE ONLY) or 51 45 184 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR PEDAL ASSEMBLY (US ONLY)
Detach edge protection (1) in area of side trim panel (2).
Release screw (3).
Remove engine compartment lid release lever (4) from side trim panel (2).
Installation note:
Make sure EDGE PROTECTION (1) is correctly seated.
Release screw (1).
Unclip side trim panel (3) in direction of arrow from retaining points (2).
If necessary, disconnect associated plug connection and remove side trim panel (3).
Installation note:
If necessary, lever out clamps (1) remaining in bore.
Replace faulty clips (1).
Position side trim panel (2) pre-installed with clips (1) on associated bore holes and clip into place.
Replacement:
Modify REAR LID UNLOCKING SWITCH , if applicable.