Removing and installing/replacing the hydraulic cap (GS7D36SG)
IMPORTANT:
It is essential to adhere to conditions of absolute cleanliness.
Any dirty parts must be cleaned before the hydraulic cap is loosened.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved transmission oil.
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Any dirty parts must be cleaned before the hydraulic cap is loosened.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved transmission oil.
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary work:
- Remove TWIN-CLUTCH GEARBOX .
Removal:
Place twin clutch transmission on a suitable surface.
To prevent the transmission oil from spilling out, make sure that the hydraulic cap points upward.
Release screws.
Remove hydraulic cover (1).
Installation:
Parts : Replace screws and seal.
Make sure seal is exactly seated.
It is mandatory to comply with the specified order of screw connections 1-12.
Tightening torque 28 60 1AZ .
Required follow-up work:
- Install the TWIN-CLUTCH GEARBOX .