Removing and installing or replacing combination sensor (GS7D36SG)
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL
.
Use only the approved transmission oil.
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the approved transmission oil.
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary work:
- Remove TWIN-CLUTCH GEARBOX .
- Remove CLUTCH .
Removal:
Release screw (1).
Release combination sensor (2) from housing.
Disconnect connector (3).
IMPORTANT:
Do not
where possible release cable (4) from bracket (5).
IMPORTANT:
To disconnect the combination sensor connector:
Press lock together in area (1) and simultaneously detach connector.
Press lock together in area (1) and simultaneously detach connector.
Installation:
Lock the combination sensor.
Make sure it engages in area (1).
Parts : Replace screw (1).
Lock connector (3).
Install the combination sensor (2)
Insert and tighten the screw (1).
Tightening torque 28 10 6AZ .
Parts : If the bracket (5) has loosened, replace the aluminium screw (6).
Tightening torque 28 10 11AZ .
Required follow-up work:
- Install the CLUTCH .
- Install the TWIN-CLUTCH GEARBOX .