65 77 551 Removing and installing impact sensor for left or right side airbag (multiple restraint system 4)

Turn ignition key to 0 position.

Remove front seat. See 52 13 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (NORMAL/MANUAL)

Remove entrance cover strip. See 51 47 000 REMOVING AND INSTALLING/REPLACING FRONT (INSIDE) LEFT OR RIGHT ENTRANCE COVER STRIP

Saloon/Sedan, Touring: 

Fold up carpet in area of front seat. If necessary, remove rear compartment heating duct.

Fig 1: Remove Rear Compartment Heating Duct (Saloon/Sedan, Touring)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug.

Fig 2: Disconnecting Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and remove impact sensor for side airbag.

Fig 3: Removing Impact Sensor For Side Airbag

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Arrow (1) on impact sensor for side airbag must point to sill.

Observe tightening torque, 5.5 N.m.

Coupe, convertible, compact: 

Remove cable strap (1).

Fig 4: Removing Cable Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew clip (2).

Fold up carpet in area of front seat.

Disconnect plug connection (1).

Release screws (2) and remove impact sensor for side airbag.

Installation: 

Arrow (3) on impact sensor for side airbag must point to sill.

Observe tightening torque, 5.5 N.m.

Fig 5: Removing Impact Sensor For Side Airbag

Courtesy of BMW OF NORTH AMERICA, INC.