Removing and installing/replacing center roof shell trim strip on left and right (M4 Convertible)

Necessary preliminary tasks: 

• Connect BATTERY CHARGER .

Move soft top into service position.

Move soft top so that angle of the hinges is not  ≤90°.

Support rear roof shell to soft top cover with suitable auxiliary materials.

Courtesy of BMW OF NORTH AMERICA, INC.

Auxiliary materials must lie over wide area and if possible over entire length.

Rear roof shell is supported by auxiliary materials on soft top cover.

Roof shells block each other.

Lift covers from the clips (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock the clips (1) and pull them out, prying them off from the rear using a plastic wedge if necessary.

Installation note: 

Ensure that the clips (1) are installed in the correct positions.

It should be possible to hear the clips (1) snap into place as they engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully remove the guide (1) for the trim strip (2) from the roof hinge.

Remove the trim strip (2).

Installation note: 

Guide (1) must not be damaged.

Ensure that the guide (1) is positioned correctly in the roof hinge.

Courtesy of BMW OF NORTH AMERICA, INC.

Use adhesive tape to secure the spring wire.

Courtesy of BMW OF NORTH AMERICA, INC.