Removing and installing (replacing) left (Xenon) headlight

WARNING: Version with xenon lighting system:

Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.

Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.

Necessary preliminary work:

NOTE: If the retaining clip (2) is present, the central connector on the headlight cannot be disconnected!

Release screw (1) and remove retaining clip (2) if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and remove cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Work shown on the F30 by way of example, deviations in detail are possible in other models.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Unfasten screws (2).

Tightening torque 63 12 1AZ .

Release screw (3).

Tightening torque 63 12 1AZ .

Release screw (1).

Tightening torque 63 12 1AZ .

Carefully remove headlight (2) in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Correctly install headlight (1) relative to holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber plugs (1) in engine compartment lid (2) must not be missing or damaged.

No cavity preservation may emerge from the rubber plugs (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: