32 31 090 Removing and installing/replacing steering column (2' Series coupe and convertible, 2017-2021)
Necessary preliminary work:
- Move steering column into "extended" position.
- Refer to CLAMPING OFF BATTERY EARTH LEAD .
- Remove airbag. Refer to REMOVING AND INSTALLING/REPLACING AIRBAG UNIT (SPORT STEERING WHEEL) .
- Remove steering wheel. Refer to REMOVING AND INSTALLING (REPLACING) M SPORTS STEERING WHEEL .
- Refer to REMOVING TRIM PANEL FOR PEDAL MECHANISM .
- Refer to REMOVING AIRBAG MODULE for driver's knee protection.
- Remove upper and lower steering column shroud. Refer to REMOVING AND INSTALLING/REPLACING UPPER SECTION OF STEERING COLUMN SHROUD .
- Refer to REMOVING STEERING COLUMN SWITCH CLUSTER .
- Unclip wiring harness and place to one side.
- Release electronics box at the spring strut dome and only lay to the side (only N47).
- Release steering shaft from steering column in engine compartment.
Undo nuts (1) at top of steering column.
See TIGHTENING TORQUE .
Secure steering column against falling out.
Undo nuts (1) at bottom of steering column.
Guide steering column out of the steering shaft collar (2) and remove.
See TIGHTENING TORQUE .
Installation note:
Align steering shaft and steering column! (encoding at spindle and joint)
With the assistance of another person, hold the universal joint in the engine compartment and slide spindle of steering column at plastic sleeve (1) from the footwell onto the universal joint.
When pushing in the steering shaft (1), ensure that the steering shaft collar is correctly positioned. Sleeve must be clipped into the firewall.
(See Removing and installing STEERING SHAFT COLLAR )
After installation:
- Turn steering wheel in both directions to the limit position. The airbag indicator light must not light up!