Remove and install support bearing for shock absorber (EDC), rear (X2 2018-2023)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 0 040

Necessary preliminary tasks:

Refer to REMOVING REAR SHOCK ABSORBER .

Removal:

Release adapter plate (2) from support bearing.

Disconnect connector (1) from shock absorber.

Remove adapter plate (2).

G11648680

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) with special tool 33 0 040, reversible ratchet with extension and socket SW10.

Remove spring strut mounting (2).

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber!

G11648681

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit support bearing (2).

Part: Replace nut (1).

Tighten down nut (1) with special tool 33 0 040, reversible ratchet with extension, socket SW10 and torque wrench with ring spanner attachment SW21.

Tightening torque 33 52 3AZ .

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber!

G11648685

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to shock absorber.

Fit adapter plate (2) on support bearing and engage.

G11648680

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Refer to INSTALLING REAR SHOCK ABSORBER .