Installing both actuators

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Hot surfaces .
Risk of burning!

Perform all work only on components that have cooled down.

NOTE: RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .

Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
Read and comply with user information on using the associated special tool 12 7 060.
Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Feed in actuator (1) for exhaust side and position.
Lock actuator (1) for exhaust side with special tool 2 360 895 in arrow direction .
Make sure that actuator (1) for exhaust side engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in actuator (1) for intake side and position.
Lock actuator for (1) intake side with special tool 2 360 895 in arrow direction .
Make sure that actuator (1) for intake side engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect connectors (1) and lock.
Connect connectors (2) and lock.
Make sure you can hear the connectors (1) and (2) engage.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the wiring harness section (1) and install.
Make sure that locking mechanisms in marked area engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to PREPARING FOR THE INSTALLATION OF THE CLEAN AIR PIPE .
Refer to INSTALLING CLEAN AIR PIPE .
Refer to INSTALLING THE REAR BULKHEAD .
Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
Refer to INSTALLING THE REAR HOOD SEAL .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE STRUT BRACE .
Refer to INSTALLING INTAKE SILENCER HOUSING .
Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .