Installing the propeller shaft center bearing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the center bearing (1)
.
Parts: Central mount
- Push the central mount (1)
onto the grooved ball bearing and press it on with the special tool 0 491 591 (23 2 430) in arrow direction
.
- Replace the flange nut (3)
, circlip (2)
and the sealing ring (1)
.
Parts: Flange nut, circlip and sealing ring
- Install the flange nut (3)
, circlip (2)
and the sealing ring (1)
.
- Push the front prop shaft and the rear prop shaft together in the arrow direction and screw together.
Follow-up work
- Refer to INSTALLING PROP SHAFT .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING FRONT HEAT SHIELD .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CROSS-MEMBER WITH TORSION STRUTS .
- Refer to INSTALLING THE CONNECTING SUPPORT ON THE TUNNEL AT FRONT AND REAR .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .