Installing front centering for the prop shaft
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Component with heavy weight
.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
NOTE:
RISK OF DAMAGE
Damage to prop shaft during removal .
Non-observance of the removal guidelines for the prop shaft on the rear axle differential may cause severe damage .
Damage to prop shaft during removal .
Non-observance of the removal guidelines for the prop shaft on the rear axle differential may cause severe damage .
- Do not disassemble the three-hole flange, flexible disc and prop shaft. The three-hole flange to the rear axle differential is balanced with the flexible disc and prop shaft.
- Loosen the recessed nut against the direction of travel in clockwise direction. The prop shaft must be loosened on the recessed nut only and exclusively in the direction of rotation otherwise the anti-twist lock of the bi-hexagonal flange nut is damaged.
- In the event of a damaged anti-twist lock on the bi-hexagonal flange nut: Replace the rear axle differential.
Preliminary work
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL AT FRONT AND REAR .
- Refer to REMOVING THE CROSS STRUT WITH THE TORSION STRUT .
- Refer to REMOVING FRONT HEAT SHIELD .
- Refer to REMOVING HEAT SHIELD AT REAR .
- Refer to REMOVING PROP SHAFT .
- Remove grease from center bore.NOTE: The plastic central mount must not be greased.
- Drive centering into the prop shaft using the special tools 0 490 818 (11 2 030)
and 0 490 475 (00 5 500) (observe protrusion)
.
- Observe the protrusion of the centering (1) .
(A) = 6 mm