Installing all gates

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Have the special tool 2 359 089 ready.

Courtesy of BMW OF NORTH AMERICA, INC.
Clean contact surfaces (1) and (2) and remove the oil, grease and dirt.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the gate (2) and hand-tighten the screw (1) .
Make sure the intermediate lever (3) is in the correct installation position.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the special tool 2 359 089 on the cylinder head.
Pre-tension the gate with the lever (3) .
Abut the screw (1) in the area (2) .
Make sure that the special tool 2 359 089 does not rotate during this process.

Courtesy of BMW OF NORTH AMERICA, INC.
Secure the gate with the lever (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure that the special tool 2 359 089 rests flat against the cylinder head (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.
Press the special tool onto the cylinder head 2 359 089 in arrow direction and tighten the screw (1) simultaneously.
TIGHTENING TORQUE SPECIFICATIONS

Gate to bearing bracket

M7x35 23 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Check the conventional gauge (1) in the area (A) for the correct gap dimension.

TECHNICAL DATA SPECIFICATION

Gap dimension between gate and bearing bracket
	Gap dimension A	0.03 mm

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure the gate (1) lies correctly against the bearing bracket (2) .
The gate (1) is correctly installed in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure that the gate lies (1) correctly on the bearing bracket (2) .
The gate (1) is not correctly installed in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.
Repeat the step for all the gates.

Gate to bearing bracket
M7x35	23 Nm