Install the DSC control unit
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
- Connect DSC control unit carefully to hydraulic unit.
- Replace screws (1)
to (3)
.
Parts: Screws
- Tighten screws (1) to (3) in this order in stages.
TIGHTENING TORQUE SPECIFICATIONS
| DSC control unit on hydraulic unit | ||
| Screw Replace screws. Screw in screws and evenly tighten crosswise. |
Tightening torque | 5.5 Nm |
- Install holder (2) .
- Insert screws (1) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Hydraulic control unit to holder | ||
| M6 Replace screws. |
Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING HYDRAULIC UNIT .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to INSTALLING THE REAR COWL PANEL .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .