Installing the tandem brake master cylinder
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the tandem brake master cylinder (1) into the brake booster.
- Replace nuts (2)
.
Parts: Nuts
- Place and tighten nuts (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Tandem brake master cylinder in the brake booster | ||
| Replace nuts. M8 |
Tightening torque | 23 Nm |
- Fit brake lines (3) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING THE EXPANSION TANK .
- Refer to INSTALLING THE SYSTEM BATTERY .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .