Install hydraulic unit

• Position hydraulic unit (3).
• Insert screws (2) and tighten.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Hydraulic unit with holder on body
  Replace screws.	Tightening torque	8 Nm

• Connect the plug connection (1).
• (1) Fit brake lines and tighten.

  Hold on to square shaft, if necessary (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Brake pipe screw connection/Union screws
  	tightening torque	17 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• (1) Fit brake lines and tighten.

  Hold on to square shaft, if necessary (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE UNDERSHIELD ON THE SIDES .
• Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
• Refer to CLEANING THE CONTACT SURFACES BETWEEN THE BRAKE DISC AND THE WHEEL RIM .
• Refer to ATTACHING THE FRONT LEFT WHEEL .
• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (HIGH BRAKE) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .