Connect the bleeder unit for the brake fluid
NOTE:
TECHNICAL INFORMATION
Use only BMW-approved brake fluids.
For additional information see: "Fluid Capacities" tab for the selected vehicle.
Use only BMW-approved brake fluids.
For additional information see: "Fluid Capacities" tab for the selected vehicle.
Remove the cover of the engine compartment at the rear left
- Loosen the lock (1).
- Remove the cover (2).
NOTE:
TECHNICAL INFORMATION
Use only BMW-approved brake fluids; see "Fluid Capacities" tab for the selected vehicle.
Use only BMW-approved brake fluids; see "Fluid Capacities" tab for the selected vehicle.
NOTE:
RISK OF DAMAGE
Paint damage .
Mechanical or chemical action may lead to paint damage .
Paint damage .
Mechanical or chemical action may lead to paint damage .
- Cover up working area with specified covering material only.
- Connect the bleeder unit (1) to the brake fluid reservoir and turn on.
Observe the operating instructions of the corresponding equipment manufacturer.
- Do not exceed the tire pressure of 2 bar .