Installing fuel delivery line
- Slide the fuel supply line in the direction of the arrow into the snap fastener (2)
and lock.
The fuel supply line must be audibly engage in the snap fastener (2) .
- Secure the clamp (1) .
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Fuel line to cylinder head cover | |
| 6x18 | tightening torque 7 Nm |
- Guide the fuel delivery line (2) in and install.
- Install rubber damper (3) .
- Make sure the rubber damper (3) is fitted correct.
- Tighten the union nut (1) hand-tight.
- Tighten union nut (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Feed line to high pressure pump | |
| M14X1.5 | 26 Nm |
- Check fuel system for leak tightness.
Follow-up work:
- Refer to INSTALLING THE IGNITION COILS
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART
- Refer to INSTALLING TENSION STRUT ON SUSPENSION STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT
- Refer to INSTALLING ACOUSTIC COVER
- Refer to CONNECTING BATTERY EARTH LEAD
- Install right luggage compartment trim panel. Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES COUPE/CONVERTIBLE) or INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES GRAN COUPE SEDAN) .