Install catalytic converter
Prepare for the installation of the catalytic converter
- Replace the V-ribbon clip (1) .
Parts: V-band clamp
- Replace gasket (1) .
Parts: Gasket
- Feed in and install catalytic converter.
- Lock clamp (1) .
The clamp (1) must engage audibly.
- Tighten V-band clamp (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Catalytic converter to exhaust turbocharger | ||
|---|---|---|
| V-band clamp Replace V-band clamp. |
Tightening torque | 19 Nm |
Replace copper-coated nuts (1) .
Parts: copper-coated nuts
Tighten copper-plated nuts (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Catalytic converter to holder | ||
|---|---|---|
| M8 copper-plated nut Replace nut. |
Tightening torque | 28 Nm |
| M8 zinc-plated nut | Tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING THE EXHAUST SYSTEM .
- Refer to INSTALL THE CONNECTING SUPPORT WITH THE TENSION STRUT .
- Refer to INSTALL THE CONNECTING SUPPORT .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALL ACOUSTIC COVER .