11 65 300 Remove and install or replace the electrical actuator drive for the wastegate: Notes
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTROSTATIC DISCHARGE)
Preliminary work
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
Follow-up work
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING