11 36 126 Removing and installing/replacing exhaust side VANOS central valve (B48B)

Special tools required: 

• 2 358 122 
• 0 496 855 
• 2 450 487
• 11 6 480 

Necessary preliminary work: 

• Check TIMING 
• Remove CATALYTIC CONVERTER

Attention! 

When replacing one or more VANOS central valves: 

When removing, pay attention to  or note the identification/part number of the VANOS central valve.

A VANOS central valve must always be replaced with the same part number  .

A combination of different VANOS central valves is not  permitted!

PuMA measure 64122020  must be observed.

For further information, see the appropriate BMW parts catalogue

Courtesy of BMW OF NORTH AMERICA, INC.

Overview chart of the VANOS central valves:

8 617 694 Short VANOS central valve

7 620 689 Long VANOS central valve

8 695 709 Short VANOS central valve (increased leakage) (TZV)

8 696 446 Short VANOS central valve (reduced leakage) (TZV)

Removal: 

Attention! 

Release VANOS central valve (1) only with installed special tool 2 358 122  .

For correct fitting see repair instructions: CHECK TIMINGS .

Courtesy of BMW OF NORTH AMERICA, INC.

Remove chain tensioner (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Version 1 

To remove the central valve (1), use the changeover ratchet (2) from special tool 0 496 855  with special tool 2 450 487.

Courtesy of BMW OF NORTH AMERICA, INC.

Version 2 

Use special tool 0 496 855  to remove the central valve (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release VANOS central valve of the exhaust camshaft adjuster (1) with special tool 0 496 855  .

Courtesy of BMW OF NORTH AMERICA, INC.

Release VANOS central valve of the intake adjuster (1) with special tool 0 496 855  .

Courtesy of BMW OF NORTH AMERICA, INC.

Remove exhaust side VANOS central valve (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Mount and abut the exhaust side VANOS central valve (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install new chain tensioner.

Parts:  Chain tensioner

Tighten chain tensioner (1).

Tightening torque 11 31 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten VANOS central valve of the intake adjuster (1) with special tool 0 496 855  .

Tightening torque 11 36 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten VANOS central valve of the exhaust camshaft adjuster (1) with special tool 0 496 855  .

Tightening torque 11 36 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Remove all special tools.

Crank engine with special tool 11 6 480  twice in direction of engine rotation.

Attention! 

Do not crank engine backwards  .

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Check TIMING 
• Install CATALYTIC CONVERTER

When replacing one or more VANOS central valves, the I-level must be encoded and programmed if necessary. 

• Connect diagnosis system and follow diagnosis instructions 
• Service functions
• Power train
• Engine electronics
• Reset VANOS adaptation values
• Encode and program I-level if necessary