24 30 101 Replacing oil reservoir (GA8HP50Z, GA8HP70Z)
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
IMPORTANT:
Valid for vehicles manufactured from 08/2011 onward!
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the APPROVED TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the APPROVED TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
IMPORTANT:
When the hydraulic impulse storage is exchanged, the spring can be relaxed in pulses due to a mechanical fault in the hydraulic impulse storage, resulting in a sudden escape of oil.
Necessary preliminary work:
- Remove the TRANSMISSION OIL SUMP .
Release screws (1) (M6x20).
Release screw (2) (M6x59).
Tightening torque 24 30 5AZ .
Carefully unlock connector (3) with screwdriver.
Carefully pull out oil accumulator.
IMPORTANT:
Mounting bolts of oil accumulator must
be replaced after removal.