22 32 055 Removing and installing/replacing transmission bearing block

WARNING: This page is about a different car, the 2018 BMW 340i and 2017 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove RUBBER MOUNTS FOR TRANSMISSION MOUNTING .

Removal:

Release screws (1).

Remove transmission mounting bracket from transmission.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install transmission mounting bracket at the transmission.

Tighten down screws (1).

Tightening torque 22 32 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the RUBBER MOUNT for the transmission mounting.