REP-TAT-P-1722-02 Install transmission oil cooler
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission oil cooler (5).
- Tighten down screw (4).TIGHTENING TORQUES SPECIFICATION
Transmission oil cooler to crankcase M6 8 Nm - Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Transmission oil cooler to crankcase M6 8 Nm - Connect the transmission oil lines (1) and lock them audibly.
- Connect and audibly lock coolant line (2).
- Connect and audibly lock coolant line (1).
Follow-up work:
- Refer to INSTALLING THE INTAKE PLENUM
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to INSTALLING THE DME CONTROL UNIT
- Refer to CONNECTING THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
- Refer to INSTALLING ACOUSTIC COVER
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR
- Refer to INSTALLING THE SUPPORT FOR THE UNDERBODY PROTECTION
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION
- Install the protective plate for the fuel lines
- Connect the BATTERY EARTH LEAD
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT SYSTEM
- Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM
- Check transmission oil level, add approved transmission oil if necessary.